Manuscripts should be submitted by one of the authors of the manuscript through the online Manuscript Submission System (MSS). Regardless of the source of the word-processing tool, only electronic PDF (.pdf) or Word (.doc, .docx) files can be submitted through the MSS. There is no page limit. Only online submissions are accepted to facilitate rapid publication. The submitting author takes responsibility for the paper during submission and peer review. If for some technical reason submission through the MTS is not possible, the author can contact to email@example.com or firstname.lastname@example.org for support.
Terms of Submission
Papers must be submitted on the understanding that they have not been published elsewhere and are not currently under consideration by another journal published by any other publisher. The submitting author is responsible for ensuring that the article’s publication has been approved by all the other coauthors. It is also the authors’ responsibility to ensure that the articles emanating from a particular institution are submitted with the approval of the necessary institution. Only an acknowledgment from the editorial office officially establishes the date of receipt. Further correspondence and proofs will be sent to the author(s) before publication unless otherwise indicated. All inquiries concerning the publication of accepted papers should be addressed to email@example.com or firstname.lastname@example.org.
All manuscripts are subject to peer review and are expected to meet standards of academic excellence. If approved by the editor, submissions will be considered by peer-reviewers, whose identities will remain anonymous to the authors.
Article Processing Charges
Journal of Basic and Applied Mycology is an open access journal. Open access allow publishers to make the published material available for free to all interested online visitors. For more details about the article processing charges of Journal of Basic and Applied Mycology, please visit the Article Processing Charges information page (www.sbamjournal.com).
The paper page setup must be arranged as per journal format-
Top: 0.7" Bottom: 0.7"
Left: 1.0" Right: 1.0"
Header: 0.5" Footer: 0.5"
Title and Authorship Information
The following information should be included
Paper title (Font 16 pt, Franklin Gothic Demi; Non Italic)
Full author names (12 pt, Franklin Gothic Demi; Non Italic)
Full institutional mailing addresses (11 pt Calibri (Body) Italic)
Email addresses (11 pt Calibri (Body) Italic)
A maximum of 5 keywords should be supplied italic..
INTRODUCTION (Font 12 pt, Franklin Gothic Demi; Non Italic)
This section should be succinct, with subheadings (Italic).
MATERIALS AND METHODS (Font 12 pt, Franklin Gothic Demi; Non Italic)
This part should contain sufficient detail so that all procedures can be repeated. It can be divided into subsections if several methods are described.
RESULTS AND DISCUSSION (Font 12 pt, Franklin Gothic Demi; Non Italic)
This section may each be divided by subheadings or may be combined.
ACKNOWLEDGMENTS (Font 12 pt, Franklin Gothic Demi; Non Italic)
All acknowledgments (if any) should be included at the very end of the paper before the references and may include supporting grants, presentations, and so forth.
REFERENCES (Font 12 pt, Franklin Gothic Demi; Non Italic)
Authors are responsible for ensuring that the information in each reference is complete and accurate. All references must be numbered consecutively and citation of references in text should be identified using numbers in square brackets (e.g., “as discussed by Smith ”; “as discussed elsewhere [10, 11]”). All references should be cited within the text; otherwise, these references will be automatically removed.
Note: References should be numbered sequentially as , ,  etc. in order to their citation in text.
1. Patel, U.S., A.K. Pandey and R.C. Rajak (1997). Mycol. Res. 101(3):335-36.
2. Pandey, A.K. (1999). In: Microbial biotechnology for sustainable development and productivity (ed. R.C. Rajak). Scientific Publishers, Jodhpur, pp 94-113.
3. Agarwal, G.P. and S.K. Hasija (1986). Microorganisms in the laboratory: a laboratory guide to microbiology, mycology and plant pathology. Print House, Luchnow. pp80.
Preparation of Figures
Upon submission of an article, authors are supposed to include all figures and tables in the Word file of the manuscript. Figures and tables should not be submitted in separate files. All figures should be cited in the paper in a consecutive order. Figures should be supplied in either vector art formats (Illustrator, EPS, WMF, FreeHand, CorelDraw, PowerPoint, Excel, etc.) or bitmap formats (Photoshop, TIFF, GIF, JPEG, etc.). Bitmap images should be of 300 dpi resolution at least unless the resolution is intentionally set to a lower level for scientific reasons. If a bitmap image has labels, the image and labels should be embedded in separate layers.
Preparation of Tables
Tables should be cited consecutively in the text. Every table must have a descriptive title and if numerical measurements are given, the units should be included in the column heading. Vertical rules should not be used.
Corrected proofs must be returned to the publisher within 2-3 days of receipt. The publisher will do everything possible to ensure prompt publication. It will therefore be appreciated if the manuscripts and figures conform from the outset to the style of the journal.
ISSN: 0972-7167 (P)
ISSN: 2455-3875 (O)